Connect Two Computers using a Crossover Cable

Step 1 – Configure IP Addresses

Usually, if you are using a crossover cable to connect two computers, the computers are not connected to a LAN network. In this case, you will need to configure static IP addresses for each computer.
You have to make sure that both computers have IP addresses that are on the same subnet. For example, if you give one computer an IP address of 192.168.0.1, then you should give the second computer an IP of 192.168.0.2.
If you used the above IP addresses, you should use a subnet mask of 255.255.255.0. If you use an incorrect subnet mask, the connection will not work.
Lastly, the value for the default gateway should be the same on both machines. You can pick which IP address you want to use, but use it on both computers for the default gateway. Below is how my setup looks for one computer:

Step 2 – Crossover Cable

The second thing you need to verify is that you actually have a proper crossover cable. Basically, there are a few different types of crossover cables, but it’s best to get the standard crossover cable where the green and orange pairs are swapped and the brown and blue pairs stay in the same position.


The only pins that need to be crossed are 1,3 and 2,6. So just check your cable on both end and make sure it matches the diagram.

Step 3 – Local User Accounts

If you’re having problems accessing files both ways, you may have to create a user account on each computer that has the same name and same password. This helps get past any kind of Access is Denied errors that may pop up.
Make sure the accounts are administrator accounts also! It’s best to create a new account rather than rename a current account.

Step 4 – Disable Firewalls

Finally, you should disable the firewall on both computers to ensure that none of the file sharing ports are being blocked. You can do this by going to Control Panel and then Windows Firewall. Click on Off.



That’s about it! If you follow all these steps, each computer should be able to access the other properly. If you are having problems, post a comment here and I will try to help! Enjoy!